SkiffWorkshop
Thick Washers - 6mm x 1/16" Wide (4 Washers)
Thick Washers - 6mm x 1/16" Wide (4 Washers)
Couldn't load pickup availability
Pivot washers CNC machined and hand finished from solid phosphor bronze. These are intended to replace cage bearings of the same same.
Ordering details
- Sold as 2 sets which equals 4 washers
Dimensions
| ID | OD | Thickness |
| 0.238" | 0.492" | 0.0625" |
| 6mm | 12.50mm | 1.587mm |
Bearing Compatibility
The below knives have been found to work with this bearing.
Click here to view the full compatibility chart.
Bought the bronze washers listed as fitting the CKF Sokasha. Unfortunately they're not even close to fitting. When you put the knife back together it won't even open. Thought about trying to sand them down but not sure I can get them completely flat again. Disappointing purchase
First set were too big in diameter. Second pair was sent free of charge. This second set were too thick. Recess was freed of all hardware. Negative experience.
I recently picked up a couple of CRKs (Seb and Inkosi) and then followed that with a Kunwu Padre. Washers were on the brain so I grabbed a set to try along with some bearings. Well, I won't be installing the bearings. The washers are so smooth and the action is just butter. Too often bearings are too fast, it's fun if you want a fidget but not always the best. Give washers a try, I think it's worth it!
Work great in a few green thorn models with a little hand fitting turning already good action into great.
These are not the same diameter as the bearings of the same dimensions they do. ot work for the Evo 4.0 despite his compatability chare saying the bearings would fit.